配電柜、高低壓配電箱的安全技術要求規范
Specification for safety technical requirements of distribution cabinet and high and low voltage distribution box
1、 配電箱、開關箱的箱體材料，一般應選用鋼板，亦可選用絕緣板，但不宜選用木質材料。
1. Generally, the material of distribution box and switch box should be steel plate or insulating plate, but wood material is not suitable.
2、電箱、開關箱應安裝端正、牢固，不得倒置、歪斜。固定式配電箱、開關箱的下底與地面垂直距離應大于或等于1.3m、小于或等于1.5m；移動式分配電箱、開關箱的下底與地面的垂直距離應大于等于0.6m、小于等于1.5m。
2. The electric box and switch box shall be installed upright and firmly without inversion and skew. The vertical distance between the bottom of fixed distribution box and switch box and the ground shall be greater than or equal to 1.3m and less than or equal to 1.5m; the vertical distance between the bottom of mobile distribution box and switch box and the ground shall be greater than or equal to 0.6m and less than or equal to 1.5m.
3、進人高低壓配電柜的電源線，嚴禁用插銷連接。
3. It is strictly forbidden to connect the power lines entering the high and low voltage distribution cabinet with bolts.
4、電箱之間的距離不宜太遠。分配電箱與開關箱的距離不得超過30m。開關箱與固定式用電設備的水平距離不宜超過3m。
4. The distance between electric boxes should not be too far. The distance between distribution box and switch box shall not exceed 30m. The horizontal distance between switch box and fixed electrical equipment should not exceed 3M.
5、每臺用電設備應有各自專用的開關箱。施工現場每臺用電設備應有各自專用的開關箱，且必須滿足“一機一閘一漏”要求，嚴禁用同一個開關電器直接控制兩臺及兩臺以上用電設備（含插座）。
5. Each electrical equipment shall have its own special switch box. Each electrical equipment in the construction site shall have its own special switch box, which must meet the requirements of "one machine, one switch and one leakage". It is strictly forbidden to use the same switch to directly control two or more electrical equipment (including sockets).
6、開關箱中必須設漏電保護器，其額定漏電動作電流應不大于30mA，漏電動作時間應不大于0.1s。
6. The switch box must be equipped with leakage protector, the rated leakage action current shall not be greater than 30mA, and the leakage action time shall not be greater than 0.1s.
7、為了確保安全，所有配電箱門應配鎖，不得在配電箱和開關箱內掛接或插接其他臨時用電設備，開關箱內嚴禁放置雜物
7. In order to ensure safety, all distribution box doors should be equipped with locks. It is not allowed to connect or plug in other temporary electrical equipment in the distribution box and switch box. It is strictly forbidden to place sundries in the switch box
