電容柜不能自動投切：原因分析：
1、電流取樣信號線未接。解決辦法：接好電流取樣信號線。
2、檢查控制器熔芯是否燒壞。解決辦法：更換熔。
3、電壓偏高，控制器顯示過壓。解決辦法：調整過壓保護點。
4、電流偏小，控制器顯示超前。解決辦法：電流增大后能自動正常工作。
5、電容柜補償儀顯示過壓。解決辦法：把設定電壓值調高于實際電壓。
6、電流取樣信號線未接。解決辦法：接好電流取樣信號線。
7、補償控制儀熔芯被燒壞。解決辦法：更換熔芯。
8、電流偏小。解決辦法：待用電電流增大后進一步調試處理。
欲想了解更多的相關資訊點擊登錄我們的網址即可：
http://hdlxbj.cn
![2-150414154625194[1].JPG](/upfiles/2019/1558045916306816.jpg "1558045916306816.jpg")
Capacitor cabinet can not be automatically cut: Reasons analysis:1, current sampling signal line is not connected. Solution: Connect current sampling signal lines.2, check whether the controller melt core is burned. Solution: Replace melt.3, the voltage is high, the controller shows overpressure. Solution: adjust overpressure protection points.4, the current is small, the controller shows ahead. Solution: When the current increases, it can work automatically.5, capacitance cabinet compensator shows overpressure. Solution: Set the voltage value higher than the actual voltage.6, current sampling signal line is not connected. Solution: Connect current sampling signal lines.7, compensation control device core was burned. Solution: Replace the core.8, the current is small. Solution: After the electric current increases, further debugging treatment.For more information, please click on our website: Http://hdlxbj.cn
